What is the installation method of Fishnet Twisting Machine Exporter? What is the specific problem about the installation method?

Secondly, before the installation, it is necessary to debug whether the mold hole of the wire and the stretch of the stretch of the wires are completely symmetrical at the center.

During the entire pull -up process of the straight Fishnet Twisting Machine Exporter, there is no frequency parking and opening phenomenon, because while pulling the start, the stress will be much more than the usual friction, and this friction will be It directly affects the wear of the mold.

The wires in the straight Fishnet Twisting Machine Exporter need to be processed in advance, mainly on the surface pre -processing and thermal treatment.

1. The pre -treatment on the surface is mainly to treat the dirt and adhesion of the surface, adhere to more impurities and other wires for processing. First of all, you need to clean it, and then dry it. If the wire is used, it is necessary to pick up the first line and then dry it to pull it out. If it is a thread that appears on the surface, in addition to the above processes, it is necessary to use a polished machine to repair it to repair it to it. grind.

Second, thermal treatment is mainly for wires with uneven hardness or severe hardness. First of all, it is necessary to reduce the hardness by igniting or annealing. It also requires the good hardness of the wires to pull out the processing.

fishnet twisting machine exporter https://www.newheli.com/Do-you-know-the-key-points-of-twisting-machine-operation.html